Getting In Tune
Hey everyone!
So this week we were challenged to do some 3D designs. It’s been both tough and fun as a first timer on the subject, but Fusion 360 proved to be a pretty intuitive software. Also, this guy helped a whole lot!
After the old routine of watching the video, pausing, trying the tool, screwing up, going back to the video, rewinding, watching the instructions again, trying the tool, and so on and so forth; I finished the tutorial and felt ready to hit the ground running.
I thought of a couple of different things to make on 3D, but my ukelele is very special. It’s made of Hawaian wood and is shaped like a pineapple. It’s also small enough to where I could measure everything up with a common 30cm ruler, and had enough intricate parts to keep me entertained for a while.
So without further ado, here are the results!
